| MODEL |
RX-711 AS |
| Voltage |
220-240V AC |
| Power Consumption |
65W |
| Output Voltage |
24V |
| Temp. setting range |
200-480°C |
| Insulation Resistance |
Over 1000 Mohm |
| Leak Voltage |
Under 0.5 mV |
| Dimensions Soldering Unit |
105mm (w/o cord) |
| Control Unit |
146(L) x 115(W) x 98 (H) mm |
| Weight Soldering Unit |
41 g (w/o cord) |
| Control Unit |
1.5 kg (w/o cord) |
| Control Unit to Soldering Unit Cord Length |
1.2 m |
| Power Cord Length |
1.3 m Burn-resistant rubber power |
| |
cord with UK moulded plug |
| Ripple temp. without load |
±3°C |
| Ground Resistance |
Under 0.3 Ohm |
| ON/OFF Control |
Zero-Voltage Switch |
| ST-77 |
Soldering Iron Stand (Included) |
|
-
The RX711ASPH can be used as a stand-alone soldering station or with a Nitrogen gas generator or Nitrogen gas cylinder. With a Nitrogen gas cylinder, adjust the pressure to less than 2MPa. Taiyo recommend that only N2 is used in the pre-heat function.
-
Features a small footprint yet delivering a high capacity soldering capability.
-
The 711-AS model has a variable temperature setting from 200°C to 480°C, shown on the digital display.
-
The iron handpiece is small and lightweight and the handle is covered with a silicon rubber grip for comfort and to reduce fatigue during operation.
-
The zero-volt switch circuit controls the heater ON-OFF by using the temperature feedback system. This ensures low noise and keeps the tip temperature stable for IC and CMOS components.
|
